Departure checklist

From MITNA
Revision as of 14:34, 10 August 2012 by Ted (Talk | contribs)

Jump to: navigation, search

This is the checklist of things to do before getting underway.

  • Remove companionway boards, stow in starboard lazarette
  • Check recent log entries
  • Make log entry, including at least the following:
    • date and time
    • full name of each person on board
  • Remove guppy, stow guppy in bucket in port lazarette
  • Check holding tank level (under forward cabin port berth)
  • Check fuel level (under lower port berth cushion)
  • Check engine oil and coolant levels and top off if necessary
  • Check bilge water level and pump out if necessary (switches next to nav table)
  • Check that bilge pump rocker-switches are set to "AUTO"
  • Check that top three "Always On" breakers above sink are set to ON
    • Bilge Pumps
    • Engine
    • Fuel Pump
  • Set House battery switch to "House" (on panel above galley sink)
  • Configure electrical panels to desired operation, typically
    • Navigation Lights Master "on"
    • Navigation Instruments "on"
    • VHF radio "on"
    • Horn "on"
  • Mount ensign on stern rail (stowed on shelf above upper starboard aft berth)
  • Hoist MITNA burgee (stowed on shelf above upper starboard aft berth)
  • Give basic lecture for new sailors (must be less than 10 minutes):
    • avoiding the boom
    • lifelines and safety when going forward on deck
    • man overboard procedures
    • location and use of life jackets
    • location and use of fire extinguishers
    • VHF radio operation
    • winch operation and safety
  • Review rules with crew:
    • No toilet paper in toilet
    • Only sit-down use of toilet