Difference between revisions of "Nevermore Depart Checklist"

From MITNA
Jump to: navigation, search
m (more asynchronism)
m (refer to nav sta switches)
Line 16: Line 16:
 
* open head valves (there are 2) (see [[Random Lore | head Lore]])
 
* open head valves (there are 2) (see [[Random Lore | head Lore]])
 
* fly ensign from stern
 
* fly ensign from stern
* fly one of
+
* fly either MIT burgie, or radar reflector, from starboard spreader
** MIT burgie from starboard spreader, or
+
* switch instruments ON (??__ which switches __?? (see [[Nav_station_switches | Nav station switches]]))
** radar reflector from starboard spreader
+
* switch instruments ON (??____ which switches ______??)
+
 
* release steering wheel brake
 
* release steering wheel brake
 
* set centerboard (usually to half-way)
 
* set centerboard (usually to half-way)

Revision as of 21:25, 8 October 2007

This is the checklist of thing to do before getting underway.

  • unlock cabin, starboard lazarette, and stern lazarette. stow locks in top drawer of nav station.
  • remove companionway boards. stow in cabin.
  • make log entry. include at least the following:
    • date and time
    • name of each person on board
    • engine hours at start
    • fuel gauge reading (the gauge under quarter berth above nav station seat)
    • holding tank level (see head Lore)
  • check log entries of recent trips for equipment problems, supplies needed, etc
  • remove guppy. stow in bucket in aft lazarette.
  • check bilge for water; set nav-station panel "BILGE" DOWN to pump water out
  • set lower battery switch to "1" (for the starting battery, battery #3)
  • set nav-station panel 'MAIN' breaker to 'on'
  • open head valves (there are 2) (see head Lore)
  • fly ensign from stern
  • fly either MIT burgie, or radar reflector, from starboard spreader
  • switch instruments ON (??__ which switches __?? (see Nav station switches))
  • release steering wheel brake
  • set centerboard (usually to half-way)
  • deploy cockpit winch-handles (1 in pocket, optionally 1 in mainsheet winch)
  • -
  • start engine (can do as soon as battery switch is ON above):
    • check that engine-kill pull-knob is pushed down
    • pre-heat 10 seconds if cold starting (per engine Lore)
    • crank and start engine (set throttle about 1/4 on, then to lowest when engine starts)
    • check that cooling water is coming out with exhaust
    • check whether ammeter shows charging of battery
    • idle for 5 minutes if cold starting (per engine Lore)
    • set throttle so that ammeter shows charging if it didn't while idling
    • after running engine about 15 minutes
      • set upper battery switch to "1" or "2" (for house battery #1 or #2))
      • and immediately set lower battery switch OFF (the starting battery #3) (see battery Lore)
  • -
  • prepare to sail (while on mooring, anchor)
    • (these optional steps are listed mainly so that large crews can work simultaneously)
    • remove sailcover and compass cover
    • release steering wheel brake
    •  ?? anything required about topping lift ??
    • connect main halyard to main, take out slack, put winch-handle in dorade
    • (left to do when go to sail: remove sail ties, raise main, optionally reef, unfurl jib)


QUESTION: Do we check engine oil anymore? Either e.g. (a) each sail, or (b) 1st sail of the week?

QUESTION: Do we check cooling water level anymore?

QUESTION: Do we check battery water level? maybe e.g. (a) 1st sail of week, or (b) 1st sail of month? [NOTE that Aleida had sealed batteries; N'more doesn't.]