Shopping List

Please add here parts and supplies that are needed for the boat.

needed

• pen holder for nav station
• window gasket - fuller brush company; 12 3/8 x 5 1/4 gasket; 13.5 x 6.5 approx cutout
• hooks for fender stowage in port lazarette
• 3" blower hose, 15 feet
• in-line blower 3"
• cover for dinghy outboard
• 2 small waste bins
• snap shackles for dinghy tie-ups
• 2 3/16"D 1.5" long fastpins for hatch locks
• freshwater fill hose

• stove
  • propane hose 15'
  • shutoff valve
  • solenoid (pending inspection/refurb of previous)

• engine
  • alternator belt 39.5" (40" should be ok) 25-9425
  • transmission fluid: ?

• rigging
  • spinnaker halyard: 1/2" line, ? feet
  • main halyard: 1/2" line, ? feet
  • jib sheets: ? line, ? feet
  • main sheet: ? line, ? feet
  • 5 halyard blocks for 1/2" line (main, 2 spin, 2 jib)
  • 2 blocks for 1/2" line (main sheet)
  • boom vang tackle: 352131 (Harken 8:1 Tackle YR-XL), West Marine part no. 7358880 - ordered 15jun12
  • boom vang tube
  • traveler car: harken T3242B.HL - ordered 15jun12

completed

• 22jun12 gasket material for raw water strainer - perko
• 22jun12 stainless mesh for raw water strainer - perko approx 6" tall, 1 1/4" in/out pipes
• 17jun12 large anchor/rode bag
• 17jun12 2 large hose clamps for mast boot - 25 3/4" and 43"
• 17jun12 wood dowels - 3/4" diameter and 1 1/8" diameter to plug toerail holes
• 17jun12 hooks for line stowage in stbd v-berth bin
• 17jun12 3 cheek blocks for 1/2" line (main halyard, main sheet)
• 17jun12 two boat hooks
• 16jun12 mast boot kit
• 16jun12 2 rolls oil blotter
• 16jun12 holding tank treatment 4 bottles
• 16jun12 large fender to replace uninflatable deflated one
• 16jun12 8 1.5" high quality hose clamps for scupper T fittings
• 13jun12 binder for manuals - keith has it, will deliver to boat 07apr12
• 12jun12 fiberglass insulation for exhaust riser
• 12jun12 blower exhaust vent
• 12jun12 coolant: ethylene glycol with sodium nitrate/benzoate, 2 gallons
• 12jun12 oil: 15W40, 5 quarts
• 12jun12 45 degree 1.25" elbow bronze for seawater in
• 12jun12 nuts and lockwashers for exhaust riser
• 11jun12 two oil hoses
• 20may12 1" to 1.25" bronze coupling (via threaded reducer)
• 19may12 starter motor - deliver to wally for rebuild 11may12
• 19may12 transducer paint
• 19may12 replacement screws for prop shaft coupling - will use old ones
• 17may12 30 stainless screws oval head phillips #12 3" long
• 16may12 traveler end controls
• 13may12 stainless cotter pin sets
• 13may12 stainless hinge for top cabin/engine step
• 13may12 lock washers for engine bracket 3/8"
• 13may12 stainless screws for engine mount 3/8", 1.5" long
• 13may12 exhaust thru-hull
• 13may12 engine seawater in hose
• 13may12 bronze fittings for engine seawater in
• 13may12 prop paint
• 10may12 bottom paint - 3 gallons black - at pavilion
• 08may12 exhaust riser for perkins engine - ready to install 01apr12
• 08may12 engine bracket and engine mount - ordered by wally foster ??mar12
• 22apr12 gojo hand cleaner
• 22apr12 bleach
• 22apr12 simple green
• 22apr12 dust masks
• 22apr12 misc electrical parts (wire, breakers, lamp fixtures)
• 22apr12 misc hoses and fittings for cockpit scuppers
• 22apr12 parts trays for fasteners
•  ??apr12 hose for large manual pump
• 22apr12 fitting for exhaust thru-hull 1-3/4" thread to 2-3/8" barbed/smooth
• 01apr12 Y connector for 1-1/8" hose - ordered 01apr12 from jamestown
•  ??apr12 JABSCO 29290-1000 strum box for 1" hose
• 01apr12 whale gusher 10 rebuild kit
• 01apr12 1" antisiphon loop (seawater in to engine)
• 01apr12 10' engine stop cable plus hardware
• 01apr12 6" length of 2" ID hose - on boat
• 01apr12 Ultra Safety Systems Ultimate Mini float switch - on boat
• 01apr12 bandaids - on boat
• 01apr12 large and small wire ties - on boat
• 01apr12 large and small nylon wire clamps - on boat
• 01apr12 propane regulator - on boat
•  ??mar12 sponges - package of 6 on boat